ABB ACQ580-07, Hardware Manual

Page: 252 / 324

￭
Compliance with the EN 61800-3:2004
Definitions
EMC stands for E lectro m agnetic C ompatibility. It is the ability of electrical/electronic
equipment to operate without problems within an electromagnetic environment. Likewise,
the equipment must not disturb or interfere with any other product or system within its
locality.
First environment includes establishments connected to a low-voltage network which
supplies buildings used for domestic purposes.
Second environment includes establishments connected to a network not supplying
domestic premises.
Drive of category C3: drive of rated voltage less than 1000 V and intended for use in
the second environment and not intended for use in the first environment.
Drive of category C4: drive of rated voltage equal to or above 1000 V, or rated current
equal to or above 400 A, or intended for use in complex systems in the second
environment.
Category C2
The drive frames R6 to R9 comply with the standard with the following provisions:
1. The motor and control cables are selected as specified in the hardware manual.
2. The drive is installed according to the instructions given in the hardware manual.
3. Maximum motor cable length is 150 meters.
WARNING!
The drive may cause radio interference if used in a residential or domestic
environment. The user is required to take measures to prevent interference, in
addition to the requirements for CE compliance listed above, if necessary.
Note: Do not install a drive equipped with EMC filter on IT (ungrounded) systems. The
supply network becomes connected to ground potential through the EMC filter capacitors
which may cause danger or damage the unit.
Category C3
The drive complies with the standard with the following provisions:
1. The motor and control cables are selected as specified in the hardware manual.
2. The drive is installed according to the instructions given in the hardware manual.
3. Maximum motor cable length is 100 meters.
248 Technical data