ABB ACH550-01, User Manual

Page: 78 / 454

66 Start-up and control panel
ACH550 User's Manual
Standard display mode
Use the standard display mode to read information on the drive’s
status and to operate the drive. To go to the standard display
mode, press EXIT until the LCD display shows status
information as described below.
Status information
Top . The top line of the LCD display shows the basic status
information of the drive.
• HAND – Indicates that the drive control is local, i.e., from the
control panel (operator keypad).
• AUTO – Indicates that the drive control is remote, such as
the basic I/O (X1) or fieldbus.
• – Indicates the drive and motor rotation status as follows:
• Upper right – shows the active reference.
Center . Using parameter Group 34:
PANEL DISPLAY , the center of the LCD
display can be configured to display:
• Three signals from
Group 01:
OPERATING DATA – The default
display shows parameters 0103 (
OUTPUT FREQ
) in hertz, 0104
(
CURRENT
) in amperes and 0120 (
AI
1) as a percentage.
• A bar meter instead of each signal
value.
Control panel display Significance
Rotating arrow (clockwise or
counterclockwise)
• Drive is running and at
setpoint.
• Shaft direction is forward
or reverse.
Dotted rotating arrow Drive is running but not at
setpoint.
Stationary arrow Drive is stopped.
Dotted stationary arrow Start command is present, but
the motor is not running, e.g.
because start enable is
missing.