ABB AC 31, Assembly And Operation Manual

Page: 44 / 165

1.4.1.3.4 Technical data 07KT9x-AD
The technical data described in the existing documentation (chapter 2.2.7) are invalid for the
AC31 adapter and are replaced by the following data.
Further information:
Ä
Chapter 1.3 “System data and CS31 bus system data” on page 4
General data
Data Value
Number of digital inputs 16
Number of digital outputs 16
Number of digital inputs/outputs 16
Number of analog inputs 8
Number of analog outputs 4
Supply voltages:
-> UP -> X7 / UP (pin 54), X7 / ZP (pin 45)
-> X8 / UP (pin 64), X8 / ZP (pin 55)
-> X9 / UP (pin 74), X9 / ZP (pin 65)
See Fig. 18
-> Fuse for UP 16 A
-> Power consumption for UP 300 W (per 100W on X7, X8 and X9)
-> L+ X6 / L+ (pin 40), X6 / L+ (pin 41)
X6 / M (pin 42), X6 / M (pin 43)
See Fig. 18
-> Fuse for L+ 10 A
-> Power consumption for L+ 10 A
-> Electrical isolation between UP and L+ Yes
Number of serial interfaces 1x COM2 (for diagnosis and programming
with the Automation Builder software)
Number of serial interfaces (diagnosis) 1x DIAG (for diagnosis with the Automation
Builder software)
Number of parallel interfaces 1 special interface for connection of an
external coupler
Program memory PM590 2MB
Resolution of the integrated real-time clock 1 s
Data of the high-speed hardware counter installed:
-> Number of operating modes -> 10
-> Counting range -> 0 ... 4,294,967,295 (double word format, 32
bit)
-> Counting frequency -> Depending on operating mode
Note: At the counting input, an external
resistor of 470 Ω / 1 W must always be con-
nected upstream.
Cycle time for 1 instruction Binary: min. 0.002 µs, word: min. 0.004 µs,
floating point: min. 0.004 µs
AC31 Adapters
Replacement devices: CPU > Replacement device 07KT9x-AD
2018/09/24 3ADR010122, 8, en_US 44