Assembly Instructions / A101-H
2 Safety / 2.2 Lifting of loads
© Copyright 2019 ABB. All rights reserved.
HZTL455311P0038_EN
Rev.A
December 2019
2.2
Lifting of loads
WARNING
Suspended loads
Loads that are not attached according to regulations can cause injury to
personnel or fatal accidents.
u
Loads must always be fastened to properly functional lifting gear with a
sufficient load limit.
u
Pay attention to the correct attachment of loads on the crane hook.
u
People must not stand beneath suspended loads.
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
Fig. 1: Attachment of loads on the crane hook
Fig. 2: Attachment angle
If there are two or more suspension points, the attachment angle of 45° must not be ex-
ceeded. This prevents excessive loading due to diagonal pull.
u
Use a suitable edge guard if there are sharp edges.
u
The assembly devices must be completely screwed in and must not unscrew during use.
u
Use assembly devices only for the described applications.
Page
6
/
17
Summary of Contents for A101-H Series
Page 2: ......
