IEC17000044-1-en.vsdx
IEC17000044 V1 EN-US
Figure 109:
Merging unit
12.3.2
Setting guidelines
GUID-3449AB24-8C9D-4D9A-BD46-5DDF59A0F8E3 v1
For information on the merging unit setting guidelines, see section
61850-9-2LE communication protocol
12.4
Routes
12.4.1
Application
GUID-19616AC4-0FFD-4FF4-9198-5E33938E5ABD v1
Setting up a route enables communication to a device that is located in another
subnetwork. Routing is used when the destination device is not in the same
subnetwork as the default gateway.
The route specifies that when a package is sent to the destination device it should
be sent through the selected router. If no route is specified the source device will
not find the destination device.
12.4.2
Setting guidelines
GUID-2C4A312A-00DC-44C8-B2D9-CD0822E1C806 v1
Routes are configured using the Ethernet configuration tool in PCM600.
Operation
for the route can be set to
On
/
Off
by checking and unchecking the
check-box in the operation column.
Gateway
specifies the address of the gateway.
Destination
specifies the destination.
Destination subnet mask
specifies the subnetwork mask of the destination.
Section 12
1MRK 511 423-UEN A
Ethernet-based communication
234
Bay control REC650 2.2 IEC
Application manual
