ABB Robotics IRB 1100, Product Manual

Page: 586 / 616

6.5 Verifying the calibration
Introduction
Always verify the results after calibrating any robot axis to verify that all calibration
positions are correct.
Verifying the calibration
Use this procedure to verify the calibration result.
Note Action
See Checking the synchron-
ization position on page 587 .
Run the calibration home position program twice.
Do not change the position of the robot axes after running
the program! 1
This is detailed in section
Synchronization marks and
synchronization position for
axes on page 563
.
Adjust the synchronization marks when the calibration is
done, if necessary.
2
Write down the values on a new label and stick it on top
of the calibration label. 3
The label is located on one side of the base.
586 Product manual - IRB 1100
3HAC064992-001 Revision: C
© Copyright 20192020 ABB. All rights reserved.
6 Calibration
6.5 Verifying the calibration