20 SBC329 3U VPX Single Board Computer
Publication No. SBC329-HRM/1
3 •
Configuration
3.1 Link Configuration
The SBC329 has push-on jumpers included in the standard kit of parts; additional
jumpers may be obtained on request. These are suitable for level 1 to 3 low vibration
applications.
TIP
For Level 4 and 5 products, make links by wire-wrapping between the pin posts and then cover
these wire-wrapped links with the same conformal coating as that used on the board (usually
ACRYLIC 1B73AP
–
for details if needed). This will provide a reliable
connection under heavy shock and vibration conditions and further prevent oxidation of the
connection due to moisture ingress.
Figure 3-1 Link Positions
The diagram above shows standard 2.54 mm pitch headers for general use.
This manual refers to jumper settings as In or Out. Meanings are as follows:
In = jumper fitted -
Out = jumper not fitted -
