Solares™ Smart Spa Bathing System Operating Manual
CD0036
- 28 -
1121
Rapid Fill™ Reservoir
Draining Reservoir:
1.
Select Bathing Menu
2.
Select Reservoir Tank Drain.
3.
Select Drain Reservoir.
Note:
Do not leave water in the
reservoir between bathing sessions or
overnight.
Enabling/ Disabling AutoFill:
1.
Go to Settings.
2.
Move the “Automatic Rapid Fill™
Reservoir Fill” slider to on if you want to
enable or off if you want to disable.
Language:
The language of the user interface can
by changed by tapping on the desired
language on the left side of the settings
page.
Leave Reservoir Valve Open:
This setting will set the tub to open the
reservoir and tub drains when the
reservoir starts filling. The valve is left
open until the water passing through
the manifold is up to temp. This setting
is primarily for facilities that have to
wait a long time to get hot water to the
tub due to their plumbing. Having this
active will ensure only hot water makes
its way into the reservoir.
Minimum Reservoir Fill Temp:
Under the settings page (see above)
you will also see a “Minimum Reservoir
Fill Temp” setting. This setting allows
you to set the lowest water
temperature that you want to allow the
reservoir to fill at. If for instance you set
this to 90 and your hot water supply fell
to 89 degrees due to the hot water
heater not keeping up, then the
reservoir would stop filling for a few
minutes and then resume when the
water heater has had some time to
catch up.
Summary of Contents for Solares Smart Spa
Page 30: ......
