Solares™ Smart Spa Bathing System Operating Manual
CD0036
- 27 -
1121
Whirlpool Disinfecting Procedure
1.
Clean the tub and chair following the
Whirlpool Cleaning Procedure.
2.
Select “Continue to Disinfection” on the
touch screen.
3.
Select “Begin Disinfection” on the touch
screen.
4.
The tub drain will close and the tub will
begin filling the whirlpool plumbing with
water mixed with the correct ratio of
disinfecting solution. The whirlpool motor
will start automatically.
5.
Observe the flow of disinfectant through
the tub’s jets. Close off each of the tub’s
jets. The disinfectant should be seen
flowing from all the jets.
6.
The whirlpool motor will shut off and the
screen will prompt you to scrub the tub
surfaces and keep wet for 10 minutes.
Using the provided tub brush and the
disinfecting product in the foot-well, scrub
the tub surfaces and the chair. The tub
and chair surfaces must be kept wet for 10
minutes for proper disinfection to occur.
There is a timer counting down on the
touch screen.
7.
Select “Continue to Rinse” on the touch
screen.
Then select “Begin Rinse”.
The drain will open and the whirlpool
motor will start. Clean water will be
pumped through all jets and down the
drain. Use the shower wand to rinse the
tub and chair.
8.
When finished select “Return to Home”
on the touch screen.
Summary of Contents for Solares Smart Spa
Page 30: ......
