Solares™ Smart Spa Bathing System Operating Manual
CD0036
- 16 -
1121
6.
Adjust Tilt as needed. This screen will not
appear if auto tilt is configured.
Bathing
Adjust water temperature using the up/down
arrows to maintain a water temperature of
95-105°F (35-41°C).
Operating Shower Wand:
1.
Pull Shower Wand out of the holder,
direct wand away from resident.
2.
Select Shower to turn on.
3.
Select Shower again to turn off.
4.
Retract Shower Wand.
Whirlpool Operation:
1.
Hit “Close Drain” if
the drain is open.
2.
Start filling the tub by pressing the Tub Fill
button.
3.
If the
“Hydrologic™
Whirlpool” button is
pushed in; then Whirlpool will start
automatically when the water level is
above the whirlpool water sensor.
4.
Push the
HydroLogic™ Whirlpool
to stop
the whirlpool.
Rapid Fill™ Reservoir Filling (if applicable
):
Attention:
Monitor water temperature. Do not
use if the water temperature is above 105°F
(41°C).
1.
Select the applicable button to fill the
reservoir.
Manual fill. Tank set to fill
when button depressed. The
button will release once the tank is full and the
user will need to push it in again to repeat
filling.
Autofill. Tank set to keep
itself full. The tank will fill
whenever water is below the top sensor and
the tub is not filling.
Autofill. Fill disabled. Will not
fill the tank until the user
pushes the button.
Tub Filling from Rapid Fill™ Reservoir (if
applicable):
1.
Verify water in the reservoir is warm
enough to use by checking the reservoir
temperature in the top left-hand corner.
(Only displays if reservoir full.
2.
Select Rapid Fill™
.
Summary of Contents for Solares Smart Spa
Page 30: ......
