AB Quality Allen-Bradley 1394, User Manual

Page: 200 / 301

Publication 1394-5.0 — May 2000
A-2 Specifications
System Modules
The table below lists the specifications for system modules.
The: For the 1394 x-SJT05
1,2
is: For the 1394 x-SJT10
1,2
is: For the 1394 x-SJT22
1
is:
Rated AC input voltage 324-528V AC, 50/60 Hz
Three phase 324-528V AC, 50/60 Hz
Three phase 324-528V AC, 50/60 Hz
Three phase
AC input current 6.5A 13.0A 28.6A
Peak inrush current
4,5
(Series A and B)
3
975A 1300A 697A < 1
µ
s
Peak inrush current
4
(Series C)
697A < 1
µ
s 697A < 1
µ
s 697A < 1
µ
s
Line loss ride through 20 ms 20 ms 20 ms
Nominal bus output voltage 530/680V DC 530/680V DC 530/680V DC
Continuous power output 4/5 kW 8/10 kW 17/22 kW
Peak power output 28 kW 28 kW 136 kW
Efficiency 99% 99% 98%
Number of Electronic Cam
Profile Points 13,000 Master/slave 13,000 Master/slave 13,000 Master/slave
Weight (Series A and B) 11 kg (24.25 lb) 11 kg (24.25 lb) 12.7 kg (28.0 lb)
Weight (Series C) 10.68 kg (23.5 lb) 10.68 kg (23.5 lb) 12.9 kg (28.5 lb)
Continuous current output 7.36A 14.73A 33.8A
Peak current output 15.0A 29.46A 200A
Capacitance
(Series A and B) 220
µ
F 330
µ
F 660
µ
F
Capacitance
(Series C) 220
µ
F 345
µ
F 660
µ
F
Inductance 1000
µ
H 750
µ
H 500
µ
H
Internal shunt resistor 200W continuous, 40,000W peak (two second maximum on
time) No internal Shunt Resistor
1
The Standard GMC and GMC Turbo system modules are identical except that the GMC Turbo (1394 x-SJTxx-T) offers a SLC backplane
interface and 64K of memory with a 32-bit processor while the Standard GMC (1394 x-SJTxx-C) offers 32K of program memory with a 16-
bit processor without the SLC interface.
2
The Standard GMC (1394C-SJT xx-L) is functionally the same as the (1394x-SJTxx-C) except it supports one axis and provides two auxiliary
encoder inputs.
3
To determine the series of your module, refer to Figure P.1 in the Preface.
4
5 and 10 kW (Series C) system modules and all 22 kW system modules are limited to four contactor cycles per minute. 5 and 10 kW (Series
A and B) system modules are limited to an average of four contactor cycles per hour.
Peak inrush current for
5 and 10 kW systems
(Series A and B)
5
=
( line voltage x 1.1 x 2 )
Lsystem
( )
(C Caxes)
Where: L = Inductance
C = Capacitance