Aastra X Series, Installation And Implementation Manual

Page: 37 / 217

Page 2-37 10/2008
AMT/PTD/TR/0020/2/7/EN
2.3.2 Configuring an M90x mobile terminal
Registering an M90x mobile terminal
A. Check that the mobile has not already been registered.
The portable handset must not contain any "parasite" registrations (for example, from previous
use on another DECT system). In the standard case where the mobile is to be used on one
DECT system only, it must not be registered on any other base at the outset.
• At startup, if the handset displays:
it is not currently registered on any other base. Press the OK key
and proceed to step 7 under paragraph B).
• If the mobile displays:
it is already registered on at least one other base.
1
Press the Menu key
2
Press the middle key until "Select base" is displayed
3
Press the key: choose base station
• Any base numbers already in use are displayed. These numbers must be de-registered
on the mobile.
B. Register the mobile on a base
1
Press the Menu key
2
Press the middle key until “Personalize” is displayed
3
Press the Personalize key
4
Press the middle key or several times until "Declare" is displayed
5
Press the Declare key
The display shows: "Declare base no. 1 2 3 4 5 6 7 8".
6
Press the or key to select base 1 2 3 4 5 6 7 8.
Normally, 1 blinks and you just have to press the OK key.
7
"Enter code" appears on the display
Enter the "set PBX registration code" and press OK .
The set displays "Please Wait".
• "Still waiting"
• "Declare base OK" or "Failed, Retry"
Stop and restart the mobile, then check to see if it is active.
Declare mobile set
to rbs nbr ?
1 2 3 4
OK
½
½
Mobile set
out of range
bis
Menu ½
½
¾
½
½
¾
¾
½ ¾
¾
½ ¾
½