BluStar 8000i Settings
41-001390-00 Rev 02 – 12.2011
4-24
Voicemail
Pressing the voicemail button on the BluStar 8000i allows a user to directly dial their voicemail and access their messages.
Administrators can setup the voicemail feature using the configuration files. The BluStar 8000i phone displays up to 99
voicemail messages for an account even if the number of voicemail exceeds the limit.
Message Indicator
The voicemail button will show a message indicator that increments the number of new voicemail messages. In PBX
mode, a (!) may display instead of a number to indicate that there is a new voicemail.
Once a user touches the voicemail button to listen to the messages, the message indicator will disappear from the button.
To Configure Voicemail:
You can setup voicemail in the configuration files using the “
sip vmail
” parameter to dial a specific number to access an
existing voicemail account. The user then follows the voicemail instructions for listening to voicemails.
Use the following procedure to enable/disable voicemail:
Using Voicemail on the BluStar 8000i UI:
Configuration Files
For the specific parameter(s) you can set in the configuration files, see Appendix A, the section,
.
Note:
The SIP account used on the BluStar 8000i must have a configured voicemail box.
1.
On the BluStar 8000i UI, touch the
voicemail
button.
You will be connected to a voicemail server where you can enter in your password to retrieve your messages.
