Aastra BLUESTAR 8000I, Pbx-Mode Administrator Manual

Page: 52 / 143

BluStar 8000i Settings
41-001390-00 Rev 02 – 12.2011
4-2
BluStar 8000i Settings
Terminal Identity
In the tools menu on the BluStar 8000i UI, you can specify the terminal identity connection settings used by the terminal
to communicate with your network.
When a user is logged off of a BluStar 8000i, you can enter information in the following fields on the terminal identity
screen:
Field Description
Internet Protocol
use DHCP
The BluStar 8000i is capable of querying a DHCP server
.
If DHCP is disabled, manually enter the con-
figuration server’s IP address.
For more information, see DHCP on page 3-2 .
use IPv6 Enables IP version 6 that will depreciate IP version 4.
IP address IP address of the BluStar 8000i. To assign a static IP address, disable DHCP.
For more information, see Configuring Network Settings Manually on page 3-6 .
net mask Subnet mask defines the IP address range local to the BluStar 8000i. To assign a static subnet mask,
disable DHCP.
For more information, see Configuring Network Settings Manually on page 3-6 .
default gateway The IP address of the network’s gateway or default router IP address. To assign a static Gateway IP
address, disable DHCP.
For more information, see Configuring Network Settings Manually on page 3-6 .
primary DNS Primary domain name server IP address. For any of the IP address settings on the BluStar 8000i a
domain name value can be entered instead of an IP address. With the help of the domain name serv-
ers, the domain names for such parameters can then be resolved to their corresponding IP addresses.
To assign static DNS addresses, disable DHCP.
If a host name is configured on the BluStar 8000i, you must also set a DNS.
For more information, see Configuring Network Settings Manually on page 3-6 .