IP P
HONE
FOR
MX-ONE™
33
6/1553-DBC 434 01 Uen C 2010-12-17
3
Starting the Phone
This chapter describes how to start the phone, and how to log on and off.
It also describes free seating, and how to check which software version
is used.
All system settings for your phone must be set by the system adminis-
trator before you can use the phone.
Note:
Depending on the settings in your network and telephony system,
the startup procedure in your phone may differ from the one
described in this manual. Check the display on your phone and
read the applicable sections.
3.1
Starting and Logging On
To start the phone, connect the required cables, see figure 2 on page 9.
When the phone is connected to the network, the startup procedure
starts automatically.
3.1.1
Logging On To the Network
If
LAN access control
is displayed when you start the phone, you need
to log on to the network before logging on to the telephony system.
To log on to the network, do the following:
1.
Enter the user ID and press
Log on
.
2.
Enter the password and press
Log on
.
Note:
If you do not know your user ID or your password, contact
the system administrator.
3.
The phone receives the network settings. If it fails, please try again.
If receiving network settings fails one more time, please contact the
system administrator.
Note:
If the user ID or password is not accepted, the following
message is displayed: “Failed Authentication! Check User
ID/Password!” Then press
Retry
and make a new logon attempt.
Should the logon fail again, please contact the system adminis-
trator.
4.
The phone receives the phone settings. If it fails, the phone will use
the latest settings.
