IP P
HONE
FOR
MX-ONE™
27
6/1553-DBC 434 01 Uen C 2010-12-17
By default, the phone is set to connect calls to the loudspeaker. If you
are using a headset, you can switch to the headset preset mode to have
calls connected to the headset instead.
Note:
When you lift the handset, the call is always connected to the
handset, regardless of the type of preset setting. Activation and
deactivation of
Headset Preset
can only be done when the
phone is in idle mode.
Note:
When headset preset mode is used and when automatic answer
is used, it is possible to announce a new call by a special tone in
the headset.
2.12 Option
Unit
It is possible to install an option unit in the phone. The option unit, which
is built into the foot console, provides the phone with a gigabit Ethernet
interface and an extra bell and busy signal.
Answer a call
Press .
Make a call
Press
and dial the desired number. In
headset preset mode, you are not required
to press the headset key.
Switch from headset
to handset
Lift the handset.
Switch from handset
to headset
Press
and replace the handset.
Clear a call
Press the
Clear
softkey or
.
Change volume
Press
to change the volume.
The new volume setting is stored.
Activate Headset Preset
Press
and hold for at least 4 seconds.
A short acknowledgement signal is heard.
Deactivating Headset
Preset Mode
Press
and hold for at least 4 seconds.
A short acknowledgement signal is heard.
