Operational, Basic, and Advanced Parameters
41-001343-02 REV05 – 07.2014
A-105
Voicemail Settings
Parameter
–
sip lineN autodial timeout
(N is a line number from 1 to 9)
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description
On a per-line basis, this parameter specifies the time, in seconds, that the phone waits
to dial a pre-configured number after the handset is lifted from the IP phone cradle.
If this parameter is set to 0 (hotline), the phone immediately dials a pre-configured
number when you lift the handset. If this parameter is set to a value greater than 0, the
phone waits the specified number of seconds before dialing the pre-configured
number (warmline) when you lift the handset.
Default is 0 (hotline).
Format
Integer
Default Value
0
Range
0-120
Examples
sip line1 autodial timeout: 30
Parameter
–
sip lineN vmail
(N is a line number from 1 to 9)
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description
Use this parameter in the
<mac>.cfg
file to configure the phone to dial a specific
number to access an existing voicemail account on a Service Provider’s server. The user
then follows the voicemail instructions for listening to voicemails.
Note:
The phone must have a registered voicemail account from a server for this feature to be
enabled. When no registered voicemail accounts are registered to the phone, the dis-
play shows "List Empty".
The phone displays up to 99 voicemails for an account even if the number of voicemails
exceeds the limit.
Registered account numbers/URIs that exceed the length of the screen, either with or
without the voicemail icon and the message count, are truncated with an ellipse char-
acter at the end of the number/URI string.
Format
String
Default Value
Not Applicable
Range
0-99
Example
sip line1 vmail: *97
Note:
In the above example, the user would dial *97 to access the voicemail account.
