Operational Features
5-195
41-001343-02 REV05 – 07.2014
Last Call Return (LCR) (Sylantro Servers)
Last call return (lcr) allows an administrator or user to configure a "last call return" function on a softkey or programma-
ble key. This feature is for Sylantro servers only.
You can configure the “lcr” softkey feature via the configuration files or the Aastra Web UI.
How it works
If you configure "lcr" on a softkey or programmable key, and a call comes into your phone, after you are finished with the
call and hangup, you can press the key configured for “lcr” and the phone dials the last call you received. When you con-
figure an “lcr” softkey, the label “LCR” displays next to that softkey on the IP phone. When the Sylantro server detects an
“lcr” request, it translates this request and routes the call to the last caller.
Configuring Last Call Return
Use the following procedures to configure LCR on the IP phones.
8.
Click on
Operation->Reset
9.
Click on
Restart
to restart the IP phone and apply the changes.
Note:
On the 6739i, you can configure a Last Call Return softkey using the IP Phone UI also. For more information, see the
Aas-
tra Model 6739i IP Phone User Guide
.
Configuration Files
For specific last call return (lcr) parameters you can set in the configuration files, see Appendix A, the section,
“Softkey/Programmable Key/Keypad
Key/Feature Key/Expansion Module Key/Hard Key Parameters”
on
Aastra Web UI
For the 6755i & 6757i/6757i CT:
1.
Click on
Operation->Softkeys and XML.
2.
Pick a softkey to configure for Last Call Return.
3.
In the "
Type
" field, select
Last Call Return
.
4.
In the "
Line
" field, select a line for which to apply the last call return configuration.
5.
The lcr softkey has a default state of “
Idle
”, “
Connected
”, “
Incoming
”, “
Outgoing
”.
Leave these states enabled or to disable, uncheck the check boxes as required.
6.
Click
Save Settings
to save your changes.
Aastra Web UI
