Operational Features
5-141
41-001343-02 REV05 – 07.2014
The following table details the ring splash behavior in the different call states/events when the feature is enabled for
active calls states. The behavior is consistent for all audio sources and audio mode configurations.
Considerations
The following considerations must be taken into account when using this feature:
•
When a BLF softkey’s ring splash parameter is dynamically changed , the change will not take effect until the BLF tar-
get becomes idle.
•
The playing of a ring splash will be postponed if it is not allowed to be played in the current state and will start playing
if the phone transitions to a state where the ring splash can be played. However, if the BLF target stops ringing before
the transition, the ring splash will not be played.
•
The playing of a delayed ring splash will be postponed until the delay expires. However, if the BLF target stops ringing
before the delay expires, the ring splash will not be played.
•
In scenarios where the BLF target goes into the ringing state while an initial in-call ring splash is playing or while a call
hold or call waiting reminder is playing, the secondary in-call ring splash will be played 500ms after the current event
has ended. The inverse is also true whereby call hold or call waiting reminders will be played 500ms after the BLF ring
splash, if they occur while a BLF ring splash is playing.
•
In scenarios where multiple keys are configured for periodic ring splashes and multiple BLF targets are ringing, only
one periodic ring splash for one target will be played.
•
While on an active call, if the “ring audibly enable” parameter is enabled and a call is incoming while a periodic ring
splash is playing, the periodic ring splash will stop allowing the incoming call’s ring tone to be played, and then
resume after the incoming call’s ring tone has ended.
Configuring Ring Splash Settings
Use the following parameters to configure the ring splashsettings:
Ring Signal Type for BLF/List
Administrators can also control whether or not a ring tone is played when there is an incoming call on a BLF/List-moni-
tored extension. Each BLF/List-monitored extension can be individually configured to play one of 15 different ring tones
(or to play none at all).
State
Behavior
Idle
Ring splash played through the speaker.
Active Call
Ring splash played through the speaker.
Call Waiting
Ring splash played through speaker.
Mid-Conference/Transfer Establishment
Ring splash played through speaker.
Do Not Disturb (Idle/In Call)
No ring splash played.
Hold
Ring splash played through speaker.
Ringing - Outgoing
Ring splash played through speaker.
Ringing - Incoming
No ring splash played.
Initiating a direct call pickup of the BLF target
No ring splash played.
Initiating a speed dial of the BLF target
No ring splash played.
Configuration Files
To set the ring splash on a per key basis in the configuration files for BLF, see Appendix A, the sections
on
