Softkey/Programmable Key/Keypad Key/Feature Key/Expansion Module Key/Hard Key Parameters
41-001343-02 REV05 – 07.2014
A-205
Parameter
–
hardkeyN ring splash
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description
(6867i only) When a key is configured for BLF functionality, this parameter controls the
ring splash alert pattern per key. The following alerting patterns are available:
When a key is configured for BLF functionality, this parameter controls the ring splash alert
pattern per key. The following alerting patterns are available:
•
0
: Silence (ring splash off ).
•
1
: Normal (same as current BLF ring splash).
•
2
: Normal delayed (After a delay of [x] seconds, the ring signal that is the same as the
current BLF ring splash is played [use the “ring splash delay” parameter to define the
delay]).
•
3
: Periodic (similar to the normal ring signal that is used by the phone itself. The actual
ring melody is based on the current melody set for the line to which the BLF key is
associated [use the “ring splash frequency” parameter to define the frequency inter-
val).
•
4
: Periodic delayed (same as Periodic but after a delay of [x] seconds, the ring signal that
is used by the phone is played [use the “ring splash frequency” parameter to define
the frequency interval and the “ring splash delay” parameter to define the delay]).
•
5
: Low volume (same as the current BLF ring splash but at a lower level to be less intru-
sive).
•
6
: Low volume delayed (after a delay of [x] seconds, the ring signal that is the same as
the current BLF ring splash is played at a lower level [use the “ring splash delay”
parameter to define the delay]).
•
7
: The behavior is determined by the global parameter “play a ring splash”.
–
If “play a ring splash” is defined as 0 then the feature is disabled.
–
If “play a ring splash” is defined as 1 then the behavior is the same as Normal.
–
If “play a ring splash” is defined as 2 then the behavior is the same as Normal but the
ring splash plays when idle and also during the active call state.
•
8
: In call delayed (same as Normal delayed but ring splash plays when idle and also dur-
ing the active call state [use the “ring splash delay” parameter to define the delay]).
•
9
: In call periodic (same as Periodic but ring splash plays when idle and also during the
active call state [use the “ring splash frequency” parameter to define the frequency
interval).
•
10
: In call periodic delayed (same as Periodic delayed but ring splash plays when idle
and also during the active call state [use the “ring splash frequency” parameter to
define the frequency interval and the “ring splash delay” parameter to define the
delay]).
•
11
: In call low volume (same as Low volume but ring splash plays when idle and also
during the active call state).
•
12
: In call low volume delayed (same as Low volume delayed but ring splash plays when
idle and also during the active call state [use the “ring splash delay” parameter to
define the delay]).
Note:
Ring tones are based on the current ring tone set configured on the IP phone.
