Assembly Instructions for Octagon Walk
-
In Table
Tools Needed:
Power drill or screwdriver
#2 Square Drive Bit
Hardware:
4
-
2¾” Wafer Head Bolts
75
-
2” Screws
1– Allen Wrench
Parts List
:
Table Top—2 pieces
2”x2”x36” Strips—2 pieces
Table Leg Assemblies—2 pieces
Bench Tops—4 pieces
1”x5½”x14½” Bench Leg Supports—8 pieces
1”x5½”x32” Bench Bottoms—4 pieces
Step 1
Lay the table tops upside down and bolt together. Insert the four 2¾” bolts in the predrilled holes in one
side and turn into the threaded inserts with the Allen Wrench. (See photo 1.) Now attach the 2”x2”x36”
strips as shown. Place ends in the corners and center of strip against the preinstalled 2x2 strips on the
table top. Fasten with six 2” screws in each strip and turn into the table top. (See photo 2.)
photo 1
photo 2
Step 2
Assemble the four bench legs. Take two leg supports and attach to a bench bottom. Put two 2” screws in
the predrilled holes in each end of the bench bottom and screw into one end of the leg supports. (See
photo 3.)
photo 1
photo 2
photo 3
photo 4
Step 3
Unfold a table leg assembly and place upside down
on a table. (See photo 4.) Take a bench top and
place upside down with the center 2x2 between the
2x4 leg support beams. Attach with two 2” screws on
each side. (See photos 4 & 5.)
photo 5
*Keep 2x2 even with outside edge of leg supports*
Predrilled holes in leg
supports belong at
this end
