2.Pre-Measurement Procedures - 2.1.Before Switching On the Power
1WMPD4004444
27
2.1.3. Paper Loading
The procedure for loading recording paper to the printer block is indicated below.
Load the recording paper to this product. There are two types of recording paper: paper rolls and Z-fold
paper.
For information on loading Z-fold paper, see "
Loading Z-fold Paper (Recording Paper)
CAUTION
Use only the recording paper prepared exclusively for this product (YPS106 or YPS108 for paper
roll and YPS112 for Z-fold paper) by our company. The quality of recording may not be guaranteed
if other recording paper is used, as paper feed problems may occur or the print quality may be.
Do not use the portion of the new roll where the recording paper tip is covered with tape, as colors
may not be printed normally on this area.
Raise the lever to open the printer cover.
Lever
Recording paper outlet
Printer cover
Z-fold paper inlet
Loading Roll Paper (Recording Paper)
Step 1. Attach the paper holders to the paper roll.
Attach a paper holder to both ends of the paper roll. If there is a gap between the recording paper
and the paper holder, the recording paper may not be able to be loaded or the recording position
may be shifted.
When loading a partially used roll, trim the edges for ease of loading, as shown in the figure.
The inside of the roll paper is the back side and the outside is the thermal surface that is printed on.
Summary of Contents for RA3100 Omniace
Page 1: ...RA3100 Omniace Instruction Manual 1WMPD4004444...
Page 173: ...13 Optional Parts 13 2 List of Probes Clamp Meters 1WMPD4004444 173 MEMO...
Page 174: ...13 Optional Parts 13 4 List of Spare Parts 174 1WMPD4004444 MEMO...
Page 175: ...Omniace RA3100 Instruction Manual 1WMPD4004444 1st Edition...