3-5
Chapter 3: BIOS setup
3.3.3
SATA Configuration
SATA Controller(s) [Enabled]
Allows you to enable or disable SATA devices. Configuration options: [Enabled]
[Disabled]
SATA Mode Selection [AHCI]
Allows you to set the SATA configuration.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use
AHCI (Advanced Host Controller Interface). AHCI allows the
onboard storage driver to enable advanced Serial ATA features
that increases storage performance on random workloads by
allowing the drive to internally optimize the order of commands.
[RAID]
Set to [RAID] when you want to create a RAID configuration from the SATA
hard disk drives.
SATA6G_1~6
Allows you to enable or disable Serial-ATA Ports.
Port 0~5 [Enabled]
Configuration options: [Enabled] [Disabled]
Hot Plug [Disabled]
Configuration options: [Enabled] [Disabled]
3.3.4
AMT Configuration
Intel AMT [Enabled]
Allows you to enable or disable Intel(R) Active Management Technology BIOS
Extension. The iAMT H/W is always enabled. Configuration options: [Enabled]
[Disabled]
3.3.5
PCH-FW Configuration
Firmware Update Configuration
Allows you to configure the management engine technology parameters.
Me FW Image Re-Flash [Disabled]
Allows you to enable or disable the Me FW Image Re-Flash function.
Configuration options: [Enabled] [Disabled]
