2-13
Chapter 2: Motherboard information
3.
Chassis intrusion header (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
EMB-Q170C
EMB-Q170C Chassis intrusion connector
Intrudor
Intrudor
No Intrudor
PIN1
CHASSIS
2.7 Connectors
2.7.1
Rear panel connectors
1
6
3
2
4
5
1.
Video Graphics Adapter (VGA) port.
This 15-pin port is for a VGA monitor
or other VGA-compatible devices.
2.
HDMI ports.
These ports are for High-Definition Multimedia Interface (HDMI)
connectors, and are HDCP compliant allowing playback of HD DVD, Blu-ray,
and other protected content.
3.
LAN2 (RJ-45) ports.
This port allows Gigabit connection to a Local Area
Network (LAN) through a network hub. Refer to the table below for the LAN2
port LED indications.
