Aaeon BOXER-8230AI, User Manual

Page: 21 / 45

Chapter 2 – Hardware Information 9
Co
mp
act
Fan
le
ss
E
m
be
dd
ed
AI@
Ed
ge
B
ox
PC
BO
XE
R-
82
30
AI
2.3 List of Jumpers
The board has a number of jumpers that allow you to configure your system to suit
your application.
The table below shows the function of each of the board's jumpers
Label Function
CN14 (Pin 7-8) AT/ATX mode select
2.3.1 Setting Jumpers
You can configure your system to match the needs of your application by setting
jumpers. A jumper is the simplest kind of electric switch. It consists of two metal pins
and a small metal clip (often protected by a plastic cover) that slides over the pins to
connect them. To “close” a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2 and 3. In this case you would connect either pins 1 and 2 or 2 and 3.
1 2
3
Open Closed Closed 2-3
A pair of needle-nose pliers may be helpful when working with jumpers.
If you have any questions about the best hardware configuration for your application,
contact your local distributor or sales representative before you make any changes.
Generally, you simply need a standard cable to make most connections.