A10 Thunder series 930, Installation Manual

Page: 36 / 44

A10 Thunder Series 930 Installation Guide
Sliding Rail Kit Installation
Document No.: TH-930-001 - 1/26/2015 | page 36
7. Repeat for the other outer rail.
Install the Chassis on the Rails
To install the chassis on the rails:
CAUTION: Lifting the chassis and placing it in the rails is a two-person job. If needed, use an appro-
priate lifting device.
1. Standing in front of the rack, fully extend the inner rails until the extension locks engage (if not already engaged). When
the extension locks are engaged, the rails cannot be pushed back in. The rails are now ready for insertion of the chassis.
2. With the front of the chassis facing you, lift the chassis and carefully insert the inner rails attached to the chassis into the
extended middle rails.
3. Slide the chassis toward the rear of the rack until the inner and middle rails lock together.