www.a-ts.cn A-TS Technology RT10
34
3.3.2 Parameter setting (Pa/Fn parameter)
In the menu level one, select
or
and press the
Enter to go to the parameter setting mode.
Use the Page up or Page down key to select the parameter number,
and press the Enter key to display the parameter value. Then use the Page
up or Page down key to modify the parameter value. The value will be
modified by pressing Enter key, and it will be valid in the servo control.
Press the Return key to return.
NOTE
When the parameter value is being modified, the decimal point of the
rightmost digital tube is lit, and press the Enter key to set the modified
value valid. At this time, the lit decimal point will go out. Then pressing
the Page up or Page down Key to continue to modify parameters.
To cancel the modification, don't press the Enter key, and press the
Return key. The parameter will not be modified, and the menu returns
back to the previous menu.
Parameter
PA0
Parameter
PA1
Parameter
PA98
Parameter
PA99
Parameter value
increase
Parameter
value decrease
Confirm
modification
Figure 3-4 PA parameter setting menu
