The wheelbarrow consists of four main shipping components: tray,
handles, component box, and wheel assembly. Please check to make
sure that all parts have been included from the parts list. Clear a flat
work surface and allow room to assemble the wheelbarrow.
Suggested tools: Wide Flat Screw Driver, Socket Driver with 13mm
Deep Socket, Electrical or Duck Tape.
For any questions contact customer service at 800-543-8955
WBST6 - Pneumatic Tire Model
FWBST6 - Flat Free Tire Model
NOTE:
Install hardware only by hand tightening until instructed to com
-
pletely tighten.
Step 1)
Install Tray Bolts - Insert the (2) 5-1/8” and (2) 3-3/8” square shank
bolts through the bottom tray holes and (2) 3/4” square shank bolts
through the front tray holes. Tap bolt heads with hammer if needed.
Then secure bolt heads with electrical tape or duck tape. Lay the tray
upside down on a flat work surface.
Step 2)
Install Tray Supports - Place the #WB1009 Front Tray Support
and #WB1010 Rear Tray Support over the bolts that are extended
through the tray bottom. Raised surface away from bottom of tray.
Step 3)
Install Wooden Wedges and the Handles - Position the #WB1022
Wooden Wedges and #WB1004 Handles over the tray bolts.
Step 4)
Install Both Legs - Place a #WB1003 Leg over one handle and bolts,
then secure with Serrated Flange Nuts. Then install the second leg
Step 5)
Install Leg Brace -Keeping the #WB1002 Leg Brace to the inside of
the Leg, line up holes in Brace and Legs, then secure using (4) 3/4”
Slot Head Bolts, washers, and nylon lock nuts.
Holes
toward
rear
ASSEMBLY
a
5-1/8” Bolts
a
3-3/8” Bolts
