IN LIMBO III - COMPACT MANUAL
80TAPE FX
Dunedin, New Zealand
email: [email protected]
Configure for Ext. Tap OR Expression mode:
1) Power the unit off then configure the internal dip
switches as shown below for the appropriate settings. The
bottom case needs to be opened and with a small
screwdriver push the white knobs into position.
2) Now hold the tap tempo button, wait a couple of
settings then turn the M.Speed control to the appropriate
setting. Release the tap tempo button and the setting will
be saved.
Make sure both steps have been completed.
M.SPEED
Ext. tap
mode
Expression/
CV mode
ON DIP
1
2
3
4
For Expression/CV mode.
ON DIP
1
2
3
4
For Ext tap mode.
Setting the regen swell amount:
Hold the tap tempo and then turn the Regen control to the desired position (hint - play a note to see how it
currently sounds). Once at the desired position release the tap tempo and the setting will be saved.
To test, Dial the Regen control back a little and then hold the tap tempo button again. Automatically the Regen
control is transitioned to the saved setting, once the tap is released it will return to normal. The transistion takes
about 500ms to ramp up.
POWER SUPPLY NOTES:
Voltage: 9V DC (negative tip - standard Boss style 2.1mm connector)
Typical current draw: 120mA (recommended 200mA power supply)
CV Input range: 0 to +5V
EXT tap: Active LOW (Expects to be pulled to GND)
Where possible avoid daisy chaining this unit to avoid interfernce.
Changing subdivision:
Hold the tap tempo switch for one second then turn
the DELAY control a quarter turn in any direction.
Next, move the dial to the desired subdivision as
shown on the right release the tap tempo button
when in place to set. The setting will be saved and
recalled for next use.
DELAY
3
1
