6
3-
Connect the board to a USB cable to PC, then you shall see the ports and modem in the
Windows device manager as in this screenshot:
3
Use QCOM tool with BG96/BG95/EG91/EG95
Install the QCOM tool from this location:
5G-NB-IoT/Tools at master · 5ghub/5G-NB-IoT (github.com)
To use the QCOM tool with LTE&GNSS modem, connect the computer USB port to the USB port on
the hardware board and make sure all modem serial ports are enumerated in the Windows device
manager as in figure below.
The serial ports below can be used for the following purposes:
•
USB Modem
: The USB modem interface is used for AT commands, data transmission, GNSS
data and NMEA sentences output.
•
USB AT Port
: It is used for AT commands and data transmission.
•
USB NMEA Port
: It is used for GNSS data and NMEA sentences output.
