4RF Aprisa SR, User Manual

Page: 47 / 327

Implementing the Network | 45
Aprisa SRx User Manual 1.3.0
Initial Network Deployment
Install the Base Station
To install the base station in your network:
1. Install the base station radio (see ‘Installing the Radio’ on page 54).
2. Set the radio Network ID to a unique ID in your entire network (see ‘Terminal > Device’ on page 82).
3. Set the radio operating mode to ‘base station’ (see ‘Terminal > Operating Mode’ on page 87).
4. Set the radio IP address (see ‘IP > IP Setup’ on page 121).
5. Set the radio frequencies to the frequencies you wish to operate from (see ‘Radio > Radio Setup’ on
page 92).
6. Set the radio security settings (see ‘Security > Setup’ on page 135).
Installing the Remote Stations
To install the remote stations in your network:
1. Install the remote station radio (see ‘Installing the Radio’ on page 54).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘Terminal > Device’
on page 82).
3. If repeater used in radius 1, set the network radius=2 on all network stations (see ‘Terminal > Device’
on page 82).
4. Set the radio operating mode to ‘remote station’ (see ‘Terminal > Operating Mode’ on page 87).
5. Set the radio IP address (see ‘IP > IP Setup’ on page 121).
6. Set the radio frequencies to the base station / repeater station frequencies you wish to operate from
(see ‘Radio > Radio Setup’ on page 92).
7. Set the radio security settings to the same as the base station (see ‘Security > Setup’ on page 135).
The base station will automatically allocate a node address to the new remote station.
Install a Repeater Station
To install a repeater station in your network:
1. Install the repeater station radio (see ‘Installing the Radio’ on page 54).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘Terminal > Device’
on page 82).
3. Increase the radio network radius by one on all stations in the network (see ‘Terminal > Device’ on
page 82).
4. Set the radio operating mode to ‘repeater station’ (see ‘Terminal > Operating Mode’ on page 87).
5. Set the radio IP address (see ‘IP > IP Setup’ on page 121).
6. Set the radio frequencies to base station frequencies you wish to operate from (see ‘Radio > Radio
Setup’ on page 92).
7. Set the radio security settings to the same as the base station (see ‘Security > Setup’ on page 135).
The base station will automatically allocate a node address to the new repeater station.