gen4-FTDI Display Series - GETTING STARTED MANUAL
|
4
SYSTEM REQUIREMENTS
The following subsections discuss the hardware requirements for this manual.
H
ardware Requirements
1. Intelligent Display Module and Accessories
The gen4-FT812/FT813 (adaptor board and flat flex cable) should be
included in the box delivered to you after your purchase from our website
or through one of our distributors. Please refer to the section “What’s in
the Box” for images of the display module and its accessories.
2. Host Controller
The gen4-FT812/FT813 is a display module which is driven by a host
controller. The host controller will send the commands using SPI
communication. It is entirely up to the user to select their host controller
and use it to drive the display.
Note:
The host controller is a device such as an Arduino or a Raspberry Pi. These
devices are not supplied by 4D Systems.
