4B - W4005 BÜHLER ELEVATOR MONITORING SYSTEM R9.6 – 22 May 2020
Page
8
of
48
Westfield Industrial Estate
Kirk Lane, Yeadon LS19 7LX,
United Kingdom
5.
Transportation
The system is securely packaged in a specially designed carton box with custom inserts. Nevertheless, care
must be taken during the transportation of the system as the carton contains sensitive electronic components.
If any mechanical or water damage is noticed the electronics inside the box should not be used and the end
user must contact the seller immediately to arrange for a replacement.
6.
System Components
System Component
Qty
Description
W4005NV46AI /B
1
W400 Series Elevator Controller
TS1V4AI /B
4
TouchSwitch Belt Alignment Sensor
P300V34AI /B
1
Speed Sensor
WG4A-BR /B
1
Whirligig Speed Sensor Mount
ADB910V3AI /B *
4*
Adjustable Depth Bearing Temperature Sensor
W400-CG-KIT /B**
0**
1 x 25mm Diameter Dual-entry ATEX Approved Cable Gland
2 x 25mm Diameter ATEX Approved Cable Gland
1 x 20mm Diameter ATEX Approved Cable Gland
3 x 25mm Gland Weather Seals
1 x 20mm Gland ATEX Weather Seal
W400-BSA-KIT/B
1*
4 x 1/8” Female
to M6 Male Thread Adapters
4 x M6 Seal-tights
2 x 1/8” Rp Female to 1/4" Rc Male Thread Adapters
Table 3 - System Components
* NB! This item is only included in the W4005V46-SYS2 /B system model. These can be added at a later date,
please contact your local 4B representative.
** This is an optional component and needs ordering separately
6.3
System Components Introduction
6.3.1.
W4005NV46AI /B – W400 Series Elevator Controller
The W4005NV46AI /B is a standalone controller unit which operates by reading up-to: four NTC Temperature
inputs, two Misalignment Zones (possible to add more than two sensors, see Belt Alignment Sensor section).
It can operate in a single speed mode or with two speed inputs, i.e. differential speed mode. It also has a
Motor Run input. When the motor run signal is applied to the W4005NV46AI /B, it monitors all its sensor
inputs for any fault conditions and if needed shuts down the elevator/conveyor when any of the dangerous
conditions are detected. The unit is fitted with MUTE and TEST buttons. The unit is equipped with an Ethernet
port and supports ProfiNet and Ethernet /IP protocol support for easy integration with the Siemens and
Rockwell PLCs.
6.3.2.
TS1V4AI /B – TouchSwitch™ Alignment Sensor
