16
A
S
II
Us
ers
G
ui
d
e
|
1/
24
/2
0
19
Heater Lock
The heater locking system is a new safety feature. The lock secures the heater assembly
during shipping.
Note:
Do not power on the unit prior to removing the locking screw,
THIS CAN
damage the AS
II
1 Spin the locking screw CCW to remove.
2 Insert the protective cap where the locking screw was.
3 Save the locking screw for future shipping.
Safety Shield
The AS II safety shield has a sensor installed for additional security.
•
If the safety shield is open, the AS II will not perform an operation
•
During a cycle, if the safety shield is opened, the AS II will stop the cycle immediately
Providing Air
Use of an external pressure regulator is required if the line pressure is greater than 95psi. Set
input pressure to 90-95ps before connecting compressed air line to the AS II.
•
The AS II is equipped with an 8mm instant push-in fitting
•
Push the supply hose into the fitting, making sure that the hose is fully inserted. When the
hose reaches the bottom of the fitting, it will be locked in place
•
To remove the hose, push the locking ring in and pull the hose out
