User manual
66
www.3onedata.com
V3 user configuration step:
Step 1: fill in the name of the group, select the type of authentication MD5 or Sha, fill in the authentication
password, select the type of encryption des or AES, fill in the configuration of the encrypted password;
Step 2: select the read and write views that are added to the view;
Step 3: click the "add" button.
6.6.3.5 Trap
SNMP usually uses UDP Port 161(SNMP) and 162 (SNMP-traps) based on TCP/IP protocol. SNMP
protocol agent is existed in network device. MIB (information specific to the device) is uses as device
connector. These network devices can be monitored or controlled through the agent. When trap event
happens, a message is transmitted by SNMP Trap, an available trap receiver can get this trap
information.
(Figure 6.6.3.5)
Trap configuration steps:
Step 1: fill in the trap event occurs when the message is sent to the destination IP address.
Step 2: click the "add" button.
6.6.4 RMON configuration
6.6.4.1 Event
In the menu bar followed by click on the "main menu", "advanced configuration" and "RMON
configuration", "event group" in RMON event group configuration interface, the interface can add, delete
event group and view the configuration information for a set of events.