User manual
31
www.3onedata.com
Configuring static aggregation steps:
Step 1: fill in priority in the text box set by LACP;
Step 2: in the group ID drop-down box to select the static convergence group of the group ID, the scope of
1-16;
Step 3: select Dst Mac, Src Mac, or Src & Dst Mac in the drop-down box in the load sharing method;
Step 4: select the port in the list of ports, each group is configured with 8 ports to join together;
Step 5: click the "add" button.
6.3.7.2 LACP configuration
Dynamic aggregation is a kind of system to automatically create or delete the aggregation, dynamic
aggregation group of the port to add and delete the LACP agreement is automatically completed. Only the
speed and duplex properties are the same, and the ports that are connected to the same device and have
the same basic configuration can be dynamically converged. Even if only one port can also create
dynamic convergence, this time for single port aggregation. In dynamic convergence, the LACP protocol
of the port is in the state of enable.
In the menu bar, click on the "main menu", "port configuration", " Port channel configuration ", "LACP
configuration", enter the LACP configuration interface.
(Figure 6.3.7.2)
Mode refers to the LACP negotiation model, divided into:
Active: Port normal periodic send LACP message;
Passive: Port usually do not send LACP message, once received the LACP message on the end, it will
normally send LACP message.
Configure LACP steps:
Step 1: select the dynamic (LACP) in the type of the drop-down box;
Step 2: select Active or Passive in the mode of the drop-down box;