CLI user manual
29
www.3onedata.com
Table 9.4.1 Ring3 to set and modify:
Operating
Command
Description
Configuration
Ring3
Config ring3
{1|2} <id>
<LoopType> <port>
<hellotime>
{1|2} :
1 ring group 1, 2 ring group 2
<id>:Said the ring network identification, value
of [0-255]
<LoopType>:Single,Couple,chain,Daul_homing
<portlist>:Ring network port
<hellotime>:value of [0-300]
Modify ring3
Modify ring3
{1|2} <options>
<parameter>
{1|2|3|4} :
1 ring group 1, 2 ring group 2
<options>:-H on behalf of Hellotime, -i ring
network identification, -p ring network port
<parameter>:And the parameter matching
-h|-i|-p
Example: the allocation of port 7, 8 to first groups in Ring3 ring, ring ID is 1, hellotime is 0,
the ring type Couple
Switch(Ring)#
Enable ?
{3|4}
3 --Enable SW-Ring III
4 -- Enable Rstp
Switch(Ring)#
Enable 3
[OK]
Tip: This configuration will be validated after restarting
Switch(Ring)#
config ring3 1 1 1 7,8 0
[OK]
Tip: This configuration will be validated after restarting
Example: to modify the first groups in SWRing3 ring network ports 5, 6
Switch(Ring)#
modify 1 -p 5,6
[OK]
Tip: This configuration will be validated after restarting
9.5
The RSTP configuration
RSTP enabled, can use the following command to set the RSTP.
Table 9.5.1 RSTP to set and modify.
