CLI user manual
25
Switch(Ring)#
Enable 2
[OK]
Tip: This configuration will be validated after restarting
Switch(Ring)#
config ring2 1 255 0 6,7 0
[OK]
Tip: This configuration will be validated after restarting
Example: to modify the first groups in Ring2 ring ID 1, ports 4, 5
Switch(Ring)#
modify ring2 1 -p 4,5
[OK]
Tip: This configuration will be validated after restarting
9.6 The Ring3 configuration
Ring3 enabled, can use the following command to set the Ring3.
Table 9.6.1 Ring3 to set and modify:
Operating
Command
Description
Configuration
Ring3
Config ring3
{1|2} <id>
<LoopType> <port>
<hellotime>
{1|2} :
1 ring group 1, 2 ring group 2
<id>:Said the ring network identification, value
of [0-255]
<LoopType>:Single,Couple,chain,Daul_homing
<portlist>:Ring network port
<hellotime>:value of [0-300]
Modify ring3
Modify ring3
{1|2} <options>
<parameter>
{1|2|3|4} :
1 ring group 1, 2 ring group 2
<options>:-H on behalf of Hellotime, -i ring
network identification, -p ring network port
<parameter>:And the parameter matching
-h|-i|-p
Example: the allocation of port 6, 7 to first groups in Ring3 ring, ring ID is 1, hellotime is 0,
the ring type Couple
Switch(Ring)#
Enable 3
[OK]
Tip: This configuration will be validated after restarting
Switch(Ring)#
config ring3 1 1 1 6,7 0
[OK]
