CLI user manual
23
Chapter 9 Ring configuration
9.1 Enter the ring network configuration view
The ring network configuration including:
1. The Ring1/Ring2/ Ring3 configuration;
2. Ring network information view;
3. The RSTP configuration
4. RSTP state information view
Table 9.1.1 into the ring network configuration view:
Operating
Command
Description
Enter the ring network configuration
view
ring
To perform the operation in the
system.
Example: display the current network information
9.2 Ring network state information view
Table 9.2.1 into the show ring network state information view:
Operating
Command
Description
Enter the ring network state information
view
Show ring
To perform the operation in the
system.
9.3 To enable or disable the ring
Users can use the following command to set the ring network enabled, 9.3.1 ring network to
set command:
Operating
Command
Description
Ring opening
Enable
{1|2|3|4}
1: Enable Ring1
2: Enable Ring2
3: Enable Ring3
4: Enable RSTP
Ring close
Disable
{0|1|2|3|4}
0:Disable all ring
；
1: Disable Ring1; 2:Disable Ring2;
3:Disable Ring3
；
4:Disable RSTP
Switch(Ring)# enable 3
[OK]
Tip: This configuration will be validated after restarting
Switch(Ring)# show ring
Ring III Enable
Group:1 ID: 1 port:1,2 type: Single Hello_time: 0*100ms state:Disable
Group:2 ID: 2 port:3,4 type: Single Hello_time: 0*100ms state:Disable
