CLI user manual
13
3.4 To enable or disable the port
The user can use the following command to open or close the port. By default, the port is
enabled.
Table 3.4.1 to enable or disable the port:
Table 3.4.1
Operating
Command
Description
Enable port
Enable
<portlist>
{enable|disable}
<portlist>:1, 3, 5-10 or all
Example: 3, 4, 6 closed port
Switch
（
Port) #
Enable 3,4,6 disable
[OK]
3.5 Configure the port speed and duplex mode
Table 3.5.1 configure the port speed and duplex.
Table 3.5.1
Operating
Command
Description
Configure the
port speed
and duplex
mode
Mode
<portlist>
{10h|10f|100h|100f|1000f|auto}
<portlist>:1,3,5-10 or all
mode:
10h, 10Mbps Half duplex
10f, 10Mbps Full duplex
100h, 100Mbps Half duplex
100f, 100Mbps Full duplex
1000f,1000 Mbps Half duplex
Auto: Automated negotiation
Example: Rate of 3, 4, 5 100Mbps full duplex port configuration
Switch
（
Port) #
Mode 3-5 100f
[OK]
3.6 Configure the port flow control
Table 3.6.1 to enable or disable the port flow control:
Table 3.6.1
Operating
Command
Description
Enable port flow control
Flow-con
<portlist>
enable
<portlist>:1,3,5-10 or all
Disable port flow control
Flow-con
<portlist>
disable
<portlist>:1,3,5-10 or all
Example: open port 3, 4, 5 flow control
Switch
（
Port) #
flow-con 3,4,5 enable
[OK]
