CLI user manual
12
Chapter 3 Port Configuration
Port information including link state (link or LOS), the port state (full or half), rate mode
(automatic negotiation, 10Mbps, 100Mbps), interface type (electric or optical), flow control,
port is enabled.
3.1 Port information
The Ethernet port characteristics of the switches support:
10/100Base-Tx Ethernet port can operate in half duplex, full duplex, auto negotiation mode.
Support MDI/MDIX adaptive, and able to negotiate with other network devices, automatic
selection of the most appropriate way of working and rate, which greatly simplifies the
configuration and management system; 100Base-FX port, rate of 100Mbps, working in full
duplex mode, flow control can be set.
Enter the port configuration view
Table 3.1.1 to enter the port configuration view:
Table 3.1.1
Operating
Command
Description
Enter the port configuration
view
port
In view of the system under the
3.2 Display port configuration information
Table 3.2.1 shows the command port configuration information:
Table 3.2.1
Operating
Command
Description
Display port state information
Show state
<portlist>
<portlist>:1,3,5-10 or all
Display port configuration
information
Show config
<portlist>
<portlist>:1,3,5-10 or all
Example: display port state information 3, 4, 5
Switch(Port)# show state 3,4,5
Speed Port_status Link_status Interface_type
port 3 10M HALF LOS TX
port 4 10M HALF LOS TX
port 5 100M FULL Link TX
3.3 Port configuration
Port configuration including:
1 To enable or disable the port;
2 Configure the port speed and duplex mode;
3 The allocation of port flow control;
4 Remove the statistics information of port frame;
