3nh TS Series, Operation Manual

Page: 49 / 55

Figure 51 Time Setting
3.8.10 Backlight Time
Click “Backlight Time” in the system settings interface to enter the “Backlight Time” selection interface.
It includes: "Normally Open", "1 minutes", "5 minutes", "10 minutes", "30 minutes". If selecting normally open, It
will not automatically stop the screen or shut down when there is no operation except no power.
If it is set to "1 minute", the instrument will be timed from the last operation, the screen will disappear after 60
seconds, and the instrument will automatically soft shut down after 3 minutes, and enter the power saving mode.
"5 minutes", "10 minutes", "30 minutes" is the same setting as above.
When the screen is disappear, it is able to short press the key to light up the screen, , and if the instrument is soft
shut, it is able to long press the key to wake it up. Please refer to Section 2.1 for detail. The default backlight time
is "1 minute", which makes it in power saving mode.
3.8.11 Screen Brightness
Click “Screen Brightness” in the system settings interface to enter the “Screen Brightness” interface as shown in
Figure 53.
Drag the slider to adjust the screen brightness. It can be adjusted according to the actual working conditions.
After the adjustment is completed, click the confirmation button
on the lower side to save the set time, and
click the return button to cancel the save.