50
Digital outputs/Triggering
Tracking runs
Models SE and DL
Digital outputs/Triggering
All digital output signals (also referred to as “
Triggering
”) appear on pins of
the Auxiliary Port (“Auxiliary port” on page 7). Manage these digital outputs in
the Ext-Trigger screen.
Tracking runs
The instrument can be configured to use a digital output to signal the start or
end of a run.
Enabling or Disabling run/pause digital outputs/triggers
1. From the start screen, press
Up/Down
to highlight
Setup
and
press
Enter
.
2. Select
Digital-Out
by using
Up/Down
to highlight and press
Enter
to select.
3. Press to select
Output 1.
4. Press to
enable (Run/Pse)
or
disable (Off)
run tracking.
5. If you enabled and want to reverse the trigger logic, continue below.
Otherwise, skip to step 9.
6. Press to select Logic 123, then press to enter the first data
field. The second data field is for Output 1.
7. Press
to select the second data field, then press to toggle the
logic state. The displayed logic state is for a running study.
8. Press to
exit
the Logic 123 data field.
9. If finished, press
to
exit
the screen.
Figure 4-13: Digital-Out screen
OUTPUT 1
Select Run/Pause to enable
Summary of Contents for SP-DL-1
