3M SP-DL-1, User Manual

Page: 41 / 168

28 Basic setups
Measurement setup (for community noise)
Models SE and DL
1
2

NOTE: For quick and easy access, there are three optional screens to change
the timed response and the weighting. These are in the following SoundPro
screens: Measures Set screen, View Current Study screen, and View Session
study screen.
Measurement setup (for community noise)
The measure screen is used to select community noise settings for meter 1
only. Table 3-2 below explains the settings and options.

Setting up community noise measurements
(refer to figure 3-5 below)
1. Ensure you are at the start screen.
•
If turned on, repeatedly press
On/Off/Esc
until you return to the
start screen (see Figure 3-3).
2. Press
Up/Down
to highlight
Setup
and then press
Enter .
3. Select
Measures
from the Setup screen by pressing
Up/Down
to
highlight and then press
Enter
.
4. In the
Measures
screen, press
Up/Down
to select one of the
measurements. To select second column, first press
Up/Down
arrows then
press
Right
arrow.
Figure 3-5: Measures screen for community noise settings
5. To make changes to the data fields, do one of the following:
•
L1-L4
- Press
Enter
to move to the data field. In the data field,
repeatedly press
Enter
to change your selection.
•
Press arrows to change percentage.
•
LDN
- Press
Enter
to move to data field and continue to press
Enter
to toggle between On/Off setting.
Data fields
•
Edit column 1 or column 2
fields by pressing enter
repeatedly to toggle through
selections.
Measurements
• L1-L4
• LDN, CNEL
• Lc-a, TAKTMX