16 Providing power
Checking or changing type
Models SE and DL
Battery Check screen
1. Turn on the SoundPro SE/DL by pressing
On/Off/ESC
. You will be at
the start screen.
•
If turned on, ensure you are at the start screen by pressing
On/Off/Esc
repeatedly until the start screen appears.
Figure 2-6: Selecting Setup in the Start Screen
2. Press
Up/Down
arrows to highlight
Setup
and then press
Enter .
3. In the Setup screen, select
Battery
, then press
Enter
. The Battery
Check screen appears.
Figure 2-7:
Selecting battery type in battery check screen
4. Press the softkey that corresponds with the installed battery type (See “A” or
“B” in Figure 2-7 for selection). The label above the softkey is underlined to
indicate the current selection.
5. When completed, press
On/Off/Esc
once to return to the Setup
screen
and twice to return to the start screen.
Setup
Softkey buttons
A:
Press softkey
to select Alkaline
B :
Press softkey
to select NiMH
Summary of Contents for SP-DL-1
