9nstructions for adjustment and use of Scotchflex
Assembly Press Model #3335
Please Note:
Scotchflex Assembly Presses have been designed specifically for the assembly of Scotchflex electronic
connectors to flat cable. When used for this purpose they will provide excellent service and require a minimum of
maintenance. The presses should never be used to perform other shop functions. All assembly presses have four
mounting holes in the base for securing to a bench.
General:
The recommended platen and its position is included
on the instruction sheet. The standard platen,
#3442-1A,
is provided with the assembly press and is
used for the assembly of most Scotchflex connectors.
Other platens necessary for certain Scotchflex
connectors are available through your Scotchflex
representative.
Handle
Lubricate
with light �-�JJ
grease
Locking Collar
Adjustment Collar
Slide Lat
0
Figure 1
Procedure for Adjusting Shut Height
Assembly Press Model: 3335
Note:
The shut height must always be made with the
specific locator plate in position.
1. Pull back the slide latch and remove pressure
platen. (see figure 1)
2. Loosen the knurled locking collar of the adjustment
shaft assembly.
3. Lower the handle fully. The arms will stop against
the casting.
justment
ollar
Ad.
:3;;;����
,.,.___
)J
/
JUS
I
✓
Shaft
-,/
g'ht /
�-
��
Gauge
.
i: /
� F1gure2
4. Place the #3436-1A shut height gauge supplied
with the assembly press across the locator plate
and rotate the knurled adjustment collar until the
adjustment shaft contacts the desired position on
the gauge. The shut height gauge should be able to
slip with slight resistance. (see figure 2)
For industrial use only.
Not intended for consumer sale or use.
Summary of Contents for Scotchflex 3335
Page 2: ......
