3M MG-1000, Manual

Page: 55 / 90

SST Transport and Burster Mechanism Manual 75-0302-1450-8, Version 1 Ch. 5 Testing the SST Transport Unit • 45
Chapter 5: Testing the SST Transport Unit
As a part of preventive maintenance, you should test the SST Transport and Burster in an SST
Ticket Spitter and SST Exit Verifier that you know are working properly. Testing will enable you
to see whether the SST Transport units are working properly and to catch any problems that might
occur.
Note: When you test the SST Transport in the SST Ticket Spitter, use a Burster that you know
works properly.
Testing the SST Transport in the MG-1000 SST Ticket Spitter
When you finish working with the SST Transport in an MG-1000 SST Ticket Spitter, you must test
it to be sure that it encodes and issues tickets properly. To test the SST Transport, complete the
following steps:
1. Turn the power switch ON.
2. Make sure that the Omega SST Controller is communicating properly to the CPU Board.
The message “READY” should be displayed on the SST Ticket Spitter LCD display.
Note: If you do not see the message, ensure that the coiled phone cord that connects the Omega
SST Controller and the CPU Board are connected properly.
3. Close DIP switch 7, then close DIP switch 8 on Switch Bank 4 on the SST Terminal
Board. The Burster will issue one ticket. Figure 5.1 illustrates an SST Ticket Spitter/Exit
Verifier Terminal Board.