3443-112 Locator Plate
3442-44 Platen
3442-1A Platen
Instructions for the assembly of
8250 and 8350 D Sub Connectors.
Recycled paper
40% Pre-consumer waste paper
10% Post-consumer waste paper
Litho in USA.
© 3M 1997 34-7041-8747-4 JHA/AYN
Electronic Products Division
6801 River Place Blvd.
Austin, TX 78726-9000
http://www.mmm.com/epd
General
3M
™
Manual and Pneumatic Assembly Presses and
accessory assembly equipment are recommended for the
termination of D Sub Connectors. 3M assembly equipment
is offered to reduce set-up time, to provide easier and
faster assembly, and to reduce assembly error.
The 3443-112 Locator Plate and 3442-44 Platen were
designed to assemble the 8250 D Sub Connector. The
3443-112 Locator Plate is used with the 3442-1A Platen to
assemble the 8350 D Sub Connector.
*Included with the 3343-112 Locator Plate is a 3442-44 Platen.
The 3442-44 Platen can also be purchased separately.
Assembly Press Base
Mounting Holes
(4 places)
Platen to Locator Plate
Alignment Guides
End Guide
Assembly Pocket
3443-112 Locator Plate
3M cable types can be
assembled to either connector
with the 3443-112 Locator Plate.
Adjustment
Shaft Mount
Platen Clip
3442-44 Platen
(3442-1A not shown)
Connector
Part number
8250
8350
Locator
Plate Number
*3443-112
*3443-112
Platen
Part Number
3443-44
3443-1A
Assembly Presses
3640/3316
15
20
Assembly Presses
3335/3339-1
15 1/2
20 1/2
Assembly
Press
3830
3830
3436-1A Shut Height Setting
Figure 1: 3443-112 Locator Plate
Procedures for set-up:
Adjust the shut height setting (see Figures 2 through 4).
Important N o t i c e
All statements, technical information, and recommendations related to
Seller’s products are based on information believed to be reliable, but the
accuracy or completeness thereof is not guaranteed. Before utilizing the
product, the user should determine the suitability of the product for its
intended use. The user assumes all risks and liability whatsoever in
connection with such use.
Any statements or recommendations of the Seller which are not contained
in the Seller’s current publications shall have no force or effect unless
contained in an agreement signed by an authorized officer of Seller. The
statements contained herein are made in lieu of all warranties, expressed
or implied, including but not limited to the implied warranties of
merchantability and fitness for a particular purpose which warranties are
hereby expressly disclaimed.
SELLER SHALL NOT BE LIABLE TO THE USER OR ANY OTHER PERSON
UNDER ANY LEGAL THEORY, INCLUDING BUT NOT LIMITED TO
NEGLIGENCE OR STRICT LIABILITY, FOR ANY INJURY OR FOR ANY
DIRECT OR CONSEQUENTIAL DAMAGES SUSTAINED OR INCURRED BY
REASON OF THE USE OF ANY OF THE SELLER’S PRODUCTS THAT
WERE DEFECTIVE.
Contact 3M Electronic Products Division Customer
Service for health, safety and environmental
information. Technical, sales and ordering
information can also be obtained through the
Customer Service Department.
Phone:
1-800-225-5373
Fax:
1-800-325-5329
To receive this technical document via fax on demand,
call the 3M Automated Information Response System
at 1-800-225-5375. Use tech sheet number TS 0764-01.
1
