3D Universe Presents: The Unofficial FlashForge Creator X Manual
shop3duniverse.com
Page 5 of 43
800-‐689-‐4344
Unboxing
Package Contents
Along with your Creator X 3D printer, your package contains the following:
In two long boxes on the top of the package, you will find:
•
Power cable
•
USB A
•
2 filament guide tubes
•
2 spool holders
The accessory box on top of the machine includes:
•
2 extruder heads
•
SD card
•
Bolt, Hex wrench and screws kit
Under the build platform in the Creator X framework, there are:
•
2 spools of filament
Unboxing
The Creator X was carefully packed at the FlashForge factory. Please follow the un-‐boxing steps
laid out below.
Handle the package and its contents with extra care; do not use any unnecessary force.
Do not remove the thin yellow film from the heating plate. It is heat resistant tape that
improves the adhesion of the extruded plastic to the plate.
Do not remove the wrapping around the nozzle. It consists of a ceramic fiber fabric and
heat-‐resistant tape, which helps to keep the nozzle at a constant temperature.
First, put the box on the floor in a clean and flat area. Remove the top two long boxes. Set them
aside, and then pull out the cardboard packing that encloses the Creator X. Inside the two long
boxes, you will find a power cable, USB A to B cable, 2 filament guide tubes, and 2 spool
