63
Find:
Searches for a pin hole, starting at the current beam position.
Profile:
Acquires and displays the power distribution and properties of the beam.
ADC:
Shows the current intensity of the beam.
X Location:
Shows the X coordinate of the beam.
Y Location:
Shows the Y coordinate of the beam.
X Width:
Shows the beam width, in mils, in the X direction.
Y Width:
Shows the beam width, in mils, in the Y direction.
Peak/Sum Ratio:
Indicates how well the beam is focused; the higher the value, the better the focus.
Max ADC:
Shows the maximum intensity of the beam.
Save Pinhole:
Saves the X and Y locations as the pre-defined location of the pin hole that is
indicated in the list box to the right. You can change the pin hole using the dropdown window.
Note: If viewing the sensor window from the right side (B side), the
sensor 1 and sensor 2 locations will be exchanged.
70696 Revision 1C 27-Aug-08
